2questions: tolerances and hatch

[waltter]

1;if i use a drawing option parameter show_tolerances then all dimensions are set up to show it in nominal+-0.01 format but i wanna change it to nominal and then i want manually select and edit tolerated dimensions but how change the default format?

2;i did a shaft drawing and i used broken wiev with half-section but hatch gets crazy and first of broken view was overlaped by thatone of half section without breaks...



Edited by: waltter

 

[denisvragolan]

Hi.


1) As far as I know, you have to set config.pro option "tol_mode" to "nominal" before you create feature if you want to have all dimensions presented without tolerances. Post-mortem changing of this option will not do the job.


2) Maybe you should update the drawing view or entire sheet. Just maybe.