AIR CONDITIONER PANEL DESIGN

[ronneilbucago]

i'm modelling a front panel of a wall mounted air conditioner with the profile design shown below. 3 LINES joined by a point is the concept. anybody knows best way to this? I've done this anyway but features are not joined by a point.

If you can load the part it will be a big help to me. Thank in advance!!

 

[Ikram]

There can be multiple ways, I think.
Best way could be that U use "Swept Blend Tool" with "Sketch Intermediate Sections" to control the Xsection and blend it to a vertex/point in last section.

U will use three separate swept blend sections ending at one point.