BOM balloon problem

[cdl1701]

I have an assembly that is made up of 2subassemblies. When I create my view on the drawing it is of the top level assy. After I place my BOM table I then use Flat/Rec Item to break out the top level so that it shows the parts under the 2 sub assys. When I try to show BOM balloons nothing shows up. However if I do not use the Flat/Rec and the BOM table just has the 2 sub assys in it the balloons show up. I recently upgraded to Wildfire 1 from 2001. Did something change that I need to do to get them to show up or is this a bug?


Thank you for your help


Chris

 

[rrleclair]

Make sure your repeat region is set to your top level and it should work.