centrelines

[Paul04]

I normally only do solid models and never really do detailed drawings. But when I'm doing a sketch and put a centreline in, it doesn't show up on the drawing once I have pressed the show axis button. But it shows the dimension angle 45 degrees but there is no centre line. So the dimension is just there with no reference. <?:namespace prefix = o ns = "urn:schemas-microsoft-comfficeffice" />

 

[prohammy]

The centreline in a sketch, is not a centreline that you can show/erase on a drawing. If you want an axis that isn't part of a feature, then you have two choices...


1. Add a datum axis as a feature


2. Add a sketched axis point in your sketch


Kev

 

[Paul04]

I have had a go and this in sketch mode, but how do you create a datum axis on a 45 degree angle?

 

[Asho Pulsar]

Firstcreate two datum points as 45