Change direction of table

[riveyman]

Hi all,
I have a table with repeat region that is decending / right... has about 60 balloons on the drawing. Is there any way to change this table to acending / left without messing up all the balloons. I can put in a new table, already have it made, but if I do that, I'll have to reposition all the balloons... Thanks

 

[Dell_Boy]

Try

RMB on Table/Pick from List Pick (IDx)TABLE
RMB on Table/Set Rotation Origin Pick Bottom RH corner of Table


DB



Edited by: Dell_Boy

 

[riveyman]

Dell_Boy thanks but it didn't work.. I was unable to get the table to switch direction. Had to put in a whole new table and redo the balloons...

 

[Dell_Boy]

Doing as I suggested changes the anchor point. When columns are added or changed in width or the assembly is edited, the anchor point does not move; but the rest of the table moves to accomodate the changes (it does work). Maybe you didn't pick the new corner correctly.

However it will not move the header line to the bottom or reverse the direction of numbering


DB

 

[appinmi]

What Dell_Boy sais works for me. I did find out that sometimes it is hard to pick the corner you want. You have to move the mouse a little bit until the corner highlights. But when completed the table does reverse direction when inserting new rows or columns.