clipping state

[trickey_99]

I have an assembly in "Clipping State A"!


Where are the menu pic's to change the clipping state?


I want a normal section to show in 3d!


Best regads
Trickey

 

[robertib]

The 'clipping state A' is the cross-section 'A' shown in 3d.

 

[trickey_99]

Yes


The cross section is shown however half of the components are cut at the section and half are not! The section of the whole assembly shows hilighted OK!
This is in 3d mode. The drawing shows the correct section view!


Best Regards