Connection between surfaces

[Chang81]

Hello Everbody,

I am working on a simple surface model.Surface angel is 60 degree with vertical datum.I would like to make sweep on this surface.But sweep sections does not merge main surface.

If I try to make that on a solid model,I can do that with merge ends option.How can I solve this problem without long traj?

Thanks All.

 

[Zaki]

Plz post a pic atleast. So I can suggest proper technique in Pro/e

 

[Chang81]

[No message]

 

[[-Skint-]]

Extend your swept surface, You can specify either normal to your trajectory or to your plane, thorugh your cone and then trim/merge.

 

[design-engine]

exited the handle and use a fillet round on surface.

Otherwise I always try at least to build up blend surfaces from untrimmed surfaces ends.And one thing to note... revolved surfaces in Pro/E have two seams that are 180 apart from each other.When is your makeup class?I bet the guy was sick because he was scared the class new surfaces better than the instructor.
Edited by: design-engine