Coordinate of saved view

[Isair]

Hi Long time no see

I have come a cross some model, and found in this model, some cool orientation from Saved view list.

Now I want this orientation put in my start templates, but I don't know how to read coordinates, or how to orient my models according to this cool orientation.

Is there a way to read coordinates of this saved view, or is there some other way to copy this orientation into my models?

Note: this orientation is not made by some random orientation it is just perfect
here is printscreen;


Also side question, does anyone knows coordinates for ISO orient view (3D)?

TIA



Edited by: Isair

 

[jeff4136]

http://www.proesite.com/
go to Tips & Tricks -> Modeling
and look down the page for "User-Defined Default Views"
It'll show set up for Iso, Dimetric (what you're seeing) and Trimetric views.

 

[Isair]

Thanks for tip and info.
But I didn't provide more information. When I said Iso view, I didn't mean isometric, I mean ISO, due to ISO standard (if there is such standard for model orientation).

So none of those options on Olafs site don't give me desired model orientation.
Only choice is to read on some way orientation in existing model.
I would very much like to have both of those views (view mention above in screenshoot, and this ISO view) in my models.
Here is printscreen of this ISO view:

 

[dr_gallup]

Set your default view to ISO, then use this mapkey to make a named DIAMETRIC view. This assumes you already have a named FRONT view. You can use the mapkey to add the DIAMETRIC view to any part or assembly including your templates

! DIAMERTIC VIEW
mapkey dv @MAPKEY_NAMECreates a named diametric view from the front view;\
mapkey(continued) @MAPKEY_LABELDIAMETRIC VIEW;~ Command `ProCmdViewOrient` ;\
mapkey(continued) ~ Select `orient` `namedviewPH.NameVw_List`1 `FRONT`;\
mapkey(continued) ~ Activate `orient` `namedviewPH.NameVw_PB_SetCur`;\
mapkey(continued) ~ Open `orient` `SetupOptions`;~ Close `orient` `SetupOptions`;\
mapkey(continued) ~ Select `orient` `SetupOptions`1 `setup`;~ Open `orient` `SetupOptions`;\
mapkey(continued) ~ Close `orient` `SetupOptions`;\
mapkey(continued) ~ Select `orient` `SetupOptions`1 `dynorient`;\
mapkey(continued) ~ Update `orient` `spinPH.YSpinBox`-20.705000 ;\
mapkey(continued) ~ Activate `orient` `spinPH.YSpinBox`-20.705000 ;\
mapkey(continued) ~ Update `orient` `spinPH.XSpinBox`19.471000 ;\
mapkey(continued) ~ Activate `orient` `spinPH.XSpinBox`19.471000 ;\
mapkey(continued) ~ Activate `orient` `panzoomPH.ZoomFitPB`;\
mapkey(continued) ~ Input `orient` `namedviewPH.NameVw_IP` `DIAMETRIC`;\
mapkey(continued) ~ Update `orient` `namedviewPH.NameVw_IP` `DIAMETRIC`;\
mapkey(continued) ~ Activate `orient` `namedviewPH.NameVw_PB_Save`;~ Activate `orient` `OkPB`;\
mapkey(continued) ~ Command `ProCmdViewRepaint`;