nracingdev
New member
Ok guys here is an odd one that I cant figure out.
I have a very simple design (1 protrusion and chamfered sides). piece of steel plate rough dimensions .25" thick, lets say length 48"x96". this is one extrusion from top plane looking down at the .25"
I then added 4 individual chamfers on each edge, only on one face(top). the chamfers were renamed A,B,C,D respectively. I then created a family table with feature columns for the chamfers. from there i try to specify a part with Y,N designators for having a specific chamfer or not. This same thing worked fine in WF4.0 but Creo does not see them. It will open the corresponding part with no chamfers at all just the extrude. Is this a bug in Creo or am I missing something in this terrible release?
Chris
I have a very simple design (1 protrusion and chamfered sides). piece of steel plate rough dimensions .25" thick, lets say length 48"x96". this is one extrusion from top plane looking down at the .25"
I then added 4 individual chamfers on each edge, only on one face(top). the chamfers were renamed A,B,C,D respectively. I then created a family table with feature columns for the chamfers. from there i try to specify a part with Y,N designators for having a specific chamfer or not. This same thing worked fine in WF4.0 but Creo does not see them. It will open the corresponding part with no chamfers at all just the extrude. Is this a bug in Creo or am I missing something in this terrible release?
Chris
