Curve through point - Help

[foolmankh]

Hi All,


Could someone help me how to do it with Curve through point? I tried toto it many times but it doesn't work to me.


Any help would be much appreciated. Thanks


(Short tutorial if possible)


2009-05-24_221217_wire.prt.rar


ai

 

[design-engine]

looks like you did it just fine. If your going to use it for cable routing your end touching the first sweep point should be forced normal to the surface end.You should be using the Pro/CABLE option tho.

 

[sanjeevkar1]

can u send zip file for this. i can not extract .rar folders.

 

[foolmankh]

Here is zip file.


2009-05-26_055207_wire.prt.zip

 

[design-engine]

I would go a little more easy on the number of points added...

 

[foolmankh]

looks like you did it just fine. If your going to use it for cable routing your end touching the first sweep point should be forced normal to the surface end.You should be using the Pro/CABLE option tho.

Thanks Bro, I can did it with Swept Blend.

 

[Martrac]

Can anyone give me an idea of how this is done please ? how do I add points then use them within a cable route ??


Thanks in advance

 

[design-engine]

Edit definition on the curve thru points.Move to the tweak value and there you can add points which essentially multiplies the knots/spans of the surface.

 

[Martrac]

Hi Bart,


Thanks for the help ? I guess that is done in "thin wire mode" .... I'll have a try later


Regards Martin