Hello all,
I would like to create a template file of structural shapes using a design table. I have done this. Now I would like to set it up to where a user can create a new part from this template file and select the correct configuration during file creation. So that when the new file is created it does not contain the design table from the template file. Can this be done? SolidWorks 2008.
Thank you,
Tom
I would like to create a template file of structural shapes using a design table. I have done this. Now I would like to set it up to where a user can create a new part from this template file and select the correct configuration during file creation. So that when the new file is created it does not contain the design table from the template file. Can this be done? SolidWorks 2008.
Thank you,
Tom