Entrusion between Two Curved Surfaces

[kots]

Hi im a little stuck on some modeling in WF3.

i have essentially a tube that has a smaller section of tube inside in the assembly but i need to create a solid extrusion between the two surfaces on the outer tube. both surfaces are non paralell due to taper etc.

Any ideas on how to do this would be appriciated!


Edited by: kots

 

[krow72]

kots - you should just be able to copy the surfaces from the 2 tubes and then create surfaces to cap the ends off. once you merge the surfaces together you can then use solidify.


Hope this is what you were looking for.


Krow27

 

[csusie]

Extrude and use the to selected option for both sides.


FYI, the sketch does not need be be in between the 2 surfaces.