Family Table this Part?

[donha]

I think I attached the image? Wondering if any has attempted to table a part like this? I am in 2001, so the warp option is not available. I was thinking along the lines of a protrusion swept along a curve defined by points and a points file defining different point locations to define aline or radial curve? Any idea or help appreciated.


Guess I need to fugure out how to attach the image.View attachment 441
Edited by: donha

 

[swcalvert]

Don, that looks like an off-the-shelf product, are you sure you want to model it in the un-folded stage? And, it's too bad you're not in Wildfire

, because you could use flexible components to define the carture size of the wire bundle.

 

[donha]

I shelved attempting to family table the part. We maintain prints on every part we have in our products. It is an off the shelf part, so instead of attempting to table it (a personal challenge), I will just label the nominal wire diameter in a drawing table.