fishmouth pipes

[awesomealvin]

My question is

Is there a way to make the intereference inside an assembly an extrude cut?


Lets say I got a pipe going at 90 degrees at another pipe. The pipe going into it needs a "fishmouth" in order to not interfere. Is there a way for me to select the interfereing pipe and make that an extrude cut?

-AA


***I am trying to build a race car chassis for school project.

 

[mgnt8]

Edit > Component Operations > Cut Out

 

[awesomealvin]

Thanks mgnt8. However since the pipes I use are hollow I am now left with a piece floating in mid air. Is there a way to make it so it extudes as a solid pipe instead of a hollow one? I read somewhere that you can use variable sweep to do it, but I don't quite understand.

-AA

 

[nofalloff]

Check this out:

http://www.youtube.com/watch?v=8exTmHo5IYQ

designengine any progress on the hires versions?