g-code post processors

[dcs5292]

Can anyone give me some information on where i can got to get a Pro-NC training manual? I am new to the machining part of Pro-e and need a good place to start. I am also wonderingwhere i can go to get some gcode post processors, and starting information on them as well.


Anyone's help is greatly appreciated.


Thanks

 

[wsylvester]

here is a couple to get you going


[url]http://www.me.umn.edu/education/courses/me5221/Machining/pro NC2001-millVolume.html[/url]



http://www.staffs.ac.uk/~entdgc/WildfireDocs/milling.pdf

 

[jb_ro1968]

Where i can go to get some gcode post processors for pro2001, pleace.

 

[wsylvester]

you should already have some if you have Pro/manufacture.. if you don't have pro/man.. you don't really need them

 

[LABRT]

Please check our website www.brt-solutions.com or directly at [email protected]

 

[cncwhiz]

If you have maintenance with ptc you can go there and download them for free.

 

[looslib]

What is the web page address for the PTC posts?

 

[cncwhiz]

If you look thru some of the old manufacturing posts in "proecentral". There are a few threads on the issue with the link.

 

[indigo2]

Here is the direct link on PTC's Tech support page:



http://www.ptc.com/cs/cs_25/howto/ncgp4903/ncgp4903.htm



Note that current maintenance status is required to access this link.



*lots* of good info here, including posts for downloading. Check near the bottom, on the right side...



-tsl