help creating a zip-lock bag

[arroyopr]

Hello everyone:


Does anyone have a model of a zip-lock bag. Or at least know the best way to model one.


TIA


ARROYOPR.

 

[ivan sosa]

Are you trying to model it"as new" -that is to say in a closed fashion- or with its "mouth" open"?

 

[arroyopr]

Prefered in a close fashion but any help will be very much apreciated. plus i will like to show that it have air or water in it.
Edited by: arroyopr

 

[ivan sosa]

I suggest you start modeling the locking strip wit a simple extrusion and then extrude the rest of the bag sketching a rectangle as thin as the two sheets of plastic are (may be .010"to .020").


For the bag to be filled with air or water you will have to deal with some surfacing techniques, which I am not familiar with.


I hope this was of some help.



Edited by: ivan sosa

 

[arroyopr]

thank you for the reply Ivan. Well the bag change to be some kind ofbag with a qiuck connect, that hold at least 1/3 of ltr. in it. I'm lookingatsomething like an I.V. bag. Anyone else out there that could help please.