Help - Gap fill in

[foolmankh]

Hi friends,


How to fill in the gap in the picture. Pls help me with short instruction. Thanks in advanced.


Here is the fle(WF4.0) 2009-10-02_063333_bottom_shell_temp.prt.zip

 

[spidernate]

The surface needed is flat because of the previous geometry, so create a curve using the 3 edges of the bounding surfaces. Then edit>fill... merge etc.

 

[[-Skint-]]

I created it for you then realised I am on WF5


Delete your fill surface on top etc and create your sweep as a semi-circle instead of your quarter. then, looking on your DTM2 extrude a surface shaped like an " n " up the sides and over the top. Extrude it to the end of your sweep. Merge the sweep and the surface and it will fill automatically. Then create your fills to cap off etc.

 

[jsantangelo]

Looking at your file, the first surface (Surface id 4) can be made like this. This was the only change I made.


<div style="text-align: center;">http://santangelo-eng.com/proe_tuts/Sweep_fix.swf

http://santangelo-eng.com/proe_tuts/Sweep_fix.swf
</div>
Then do the Merges and Trims like you already have them. This satisfies your tangent and perpendicular constraints.

 

[design-engine]

create the geometry in a different order. Start with the surface in question. Trim it back then create the tangent surfaces.
Edited by: design-engine

 

[foolmankh]

Hi Friends,


Thanks for all help. I've got your ideas

Best Regards