Help with round

[red devil]

I am trying to add a round between the cylinder and the horizontal surface. The round needs to be 2mm where the blue curve is and goes down to zero (or near as) at each end. Does anyone know how to do this complex round?


TIA


RD

 

[rmatija]

Send File


Look this


2008-07-02_040038_radius.prt.rar
Edited by: rmatija

 

[red devil]

Here's the file.


RD


2008-07-02_040451_h-c5-15-301-33.prt.zip

 

[red devil]

Thats the sort of thing, but your part is much bigger than mine. See below:

 

[red devil]

All sorted now.


The solutions is to create the round as normal, then modify the pieces to get the desired geometry. The pieces can be found on the dashboard under the pieces tab.


Thanks to all that helped.


RD

 

[davisdony]

That is preaty good round option where the parting line will not get affected

Thanks for the knowledge

 

[Jacoolo]

there are other ways to accomplish this. However all depends ont the results You want to achieve



http://www.youtube.com/user/designengineeducatio

this is in catai. Same is possible in Pro/E. I put such pic becouse there is movie related to it on Youtube

 

[davisdony]

Hi

Jacek,



Here youtube is blocked

is there some other way to view that

can you sent me a movie file to me [email protected]

or a model with that will do

 

[Jacoolo]

Some time ago design-engine provided access to his tricks on own web site where such example was discussed. But this is no longer running.

For this moment it will be good for You to check following post

http://www.mcadcentral.com/proe/forum/forum_posts.asp?TID=33 379&PN=1&TPN=14

at top of it there is a pic and model from jeff. This model introduce one of ways which provides such results(Jeff`s one introduce G2 results, top notch!)

 

[bari1]

Use the Pieces option in round feature