indicating a C of G on a drawing

[ahldesign]

Hi folks,


Ineed to show a C of G on a drawing which has been defined from the analysis which has been done in the model?


Can i add datums to the model which automatically choose the analysis results?


Regards





Gaza

 

[SRINIVASANIYER1]

You can define a point at the CG. You can also define a co-ordinate system that will latch on to an analysis feature. I think you need behavioral modeling (BMX) to do that. I am not sure in WF3 and 4.

 

[ahldesign]

Srinivasaniyer1,


I did think you need the BMX to do that because when you press the add feature button, it states that we do not have part of Pro-e. Oh well time for the dimensins to be added manually i think.


Thanks for comfirming my thoughts.


Gaza

 

[SRINIVASANIYER1]

CHECK THIS THREAD... MIGHT BEOF HELP.

http://www.mcadcentral.com/proe/forum/forum_posts.asp?TID=37 282

 

[alli_zona]

hi,


go to>insert analysis>modelanalysis>next>compute>close

two options are there 1)Result params 2)result datums


result datums>csys_cog>create>yes

you can c the model CG.


also ref image





otherwise


save the analysis with active result params,


make a new ref-system

relate the new ref-system with the old one by relations and


params(those derived frm analysis result)


try out..

 

[SRINIVASANIYER1]

I believe the above method is applicable from WF3 onwards...

 

[pjw]

If you don't have BMX I can send you a UDF that will automatically place the COG co-ordinate system and datum point. Make sure it is always the last feature.

 

[alli_zona]

hi Mr,Iyer


frmwf3 ,it differs .


wf2 u can follow the same procedure.

 

[SRINIVASANIYER1]

frmwf3 ,it differs .


wf2 u can follow the same procedure.

Thanks.... I shall check it out.