inserting swept blend, need change arrows

[2ms1]

I am inserting a swept blend through a whole bunch of sections. In the step where u have already specified the trajectory and just need to select each cross section of the blend, little yellow arrows and yellow highlight appear to show the outline of the section/loop.

How to do change the direction and location of the arrow that appears by default?View attachment 2298

Edited by: 2ms1

 

[Zaki]

Actually if u know about this arrow, it is the start point of sketch, and in pro if u dont need a twist, u must set the start points of all sections same. To change this, just select the point or vertex which one u need to set start point then RMB and select start point. I think u understand.

 

[appinmi]

If you need to change the direction at the same start point, move pointer over vertex, right-click, then select vertex, and right-click again. Select start point.