Continue to Site

Welcome to MCAD Central

Join our MCAD Central community forums, the largest resource for MCAD (Mechanical Computer-Aided Design) professionals, including files, forums, jobs, articles, calendar, and more.

Invalid Attribute Value Restriction

JamesM

New member
I'm using Intralink 3.4. When attempting to check in a new assembly, I get a conflict screen which states "Invalid attribute value restriction" for the assembly file (all the component files can be checked in). No hint about which attribute is wrong is given, and I see no values that are different from what are normally used. Any ideas on what may be wrong?
 
One example could be if an attribute is set to something like an integer and you have mistakenly entered a letter O instead of a 0 (zero) or a letter l (lower case L) instead of a number 1 for example this would cause the error.
 
If you get a list in your errormessage, showing the files with the conflict, you can select the file and below that table the problematic parameter is shown.
 
KurtStark said:
If you get a list in your errormessage, showing the files with the conflict, you can select the file and below that table the problematic parameter is shown.


Yes,I had missed that. After doing as you described, I found the mistake easily. Thank you.
 

Sponsor

Back
Top