Okay guys, here is a challenge for you. I need some way to
be able to take all of the datum curves or Project curves in an assembly and
have there lengths added together and placed into a parameter or just be able
to repot to a table in a drawing.
Ultimately what I am looking to do is have the curves represent weld in an
assembly and then what I will do is create a relation using the length to
calculate the amount of time required to weld up the component to input as
labor hours. But that is the easy part. Hard part is just getting
all of the lengths added up with out having to do it manually.
Ideas? Suggestions?
Thanks
be able to take all of the datum curves or Project curves in an assembly and
have there lengths added together and placed into a parameter or just be able
to repot to a table in a drawing.
Ultimately what I am looking to do is have the curves represent weld in an
assembly and then what I will do is create a relation using the length to
calculate the amount of time required to weld up the component to input as
labor hours. But that is the easy part. Hard part is just getting
all of the lengths added up with out having to do it manually.
Ideas? Suggestions?
Thanks