Continue to Site

Welcome to MCAD Central

Join our MCAD Central community forums, the largest resource for MCAD (Mechanical Computer-Aided Design) professionals, including files, forums, jobs, articles, calendar, and more.

Make part from Assembly

Justpaul

New member
At the moment we are working on a large Assembly file which contains many parts, in the end this Assembly should be transformed in a Part again which would enable us to work on it as if it were a normal part.


Anybody an idea how one can make a single solid part out of a SW (2008) Assembly?


Thanks!


Paul ([email protected])
 
Did you try the function - Save as. part? you can than save the asembly with - exterior faces or exterior components or with all components.


good luck Jan
 
One other way you could do it is use the join function. I've used it to join a few parts in an assembly but never on a large number of components.


It may be worth trying though Jan's method sounds a bit easier.
 
Dear Jan & Michael,

Thanks for these helpful tips, will try to work with them this week!

Best regards,

Paul
 

Sponsor

Back
Top