mass properties

[tomislav]

Hi,


I've made a casting part in assembly (skelet, insert parts, machining part). Then I've made arelation for mass: mass=mp_mass("machining.prt"). After verifyingI've got correct mass in drawing but after regeneratingI've got mass fromwhole assembly. Problem is somewhere in config.pro butI can't find where. Has someone experience with this problem?


regards
Edited by: tomislav

 

[Jacoolo]

I suppose You can store mass for this part direct inside of it under special parameter. Let it be for example Mass

then You can use this parameter direct in drwing using component id, ie - &Mass:15