Moving, radius center lines.

[Nicholas.w]

View attachment 1245

 

[Nicholas.w]

Hey every one.
What we have here is a radius dimension of 35.00, the center of the radius (red) is out side the border of the drawing, what we need to do is move the center inside the boarder (to where its green), I know of a few ways to

 

[dr_gallup]

Broken view should work.

 

[Nicholas.w]

Thanks dr_gallup


it almost worked, i was able to move the center lines (to whare shown in green)but the dims still referenced that point in space.


Is there any way to relate the dims to thegreen center point? (while remaining parametric and Radius 35.00)

 

[Nicholas.w]

View attachment 1250

 

[jrobi]

could you make it a 'detailed' view or 'partial' view and use the entire part inside the boundry, and rely on 'clipped' dimensions to show the centerpoint as you want?

 

[jrobi]

the above mentioned does work(partial view)- you will not be able to use show dimensions, but if you place the dimensions, it will clip the witness line and at least keep it on the shet.

 

[jrobi]

ps- you can then drag your cliped dim lines to anywhere you want them with respect to the dimension. hope that works.