Multiple Holes

[John 62]

I am learning this program. I will be learning for a long time! I am moving to this program from Inventor. Inventor was a whole lot easier.


Can anybody tell me how to put multiple holes in a part?

 

[ndk]

Place a single hole, and then, use pattern tool including dimesion, direction,axial, table, fill .... Here's a tutorial for radial pattern. If you need more, don't hesitate to contact me, i'll send you


[url]http://www.me.cmu.edu/academics/courses/NSF_Edu_Proj/Wildfir e_short_course/tutorial5.htm[/url]

 

[John 62]

Can I locate a group of points & attach multiple holes to these points

 

[ndk]

Yes you can. It's reference pattern. make a datum point and pattern this point. Then, make a hole refering to this point, and pattern the hole (reference pattern). Now you can see the results