offseting a 2d skecth in pro/e

[mukesh_sood]

I am not able to offset a 2D skecth in pro/e. In case of 3D edge it is possible. But I dont think that there is a direct method to method to offset 2D skecth in pro/e.If any one can help me in this regard

 

[[-Skint-]]

Your right, its not as straight farward as it should be whilst in sketcher mode. I am assuming that you are trying to offset the sketch whilst in the same (original) sketch ?


Do the original sketch first and press tick. Then go into a second sketch and this will allow you to offset the first one.


Should do the trick ?