Hi!
Im new in wilfire2.0 and need your expertise for my problem.
Attached is a part created on proe2001. A pattern following a 3d curve.After creating the curve, i created a pointon the curve with the length ratio option. i then created my revolve protrusion using a make datum sketching plane (through point, normal to curve) and make datum reference plane for sketching (normal to created sketching plane, through point). I patterned the createdrevolved protrusion and then, viola!, the part is created.
I tried to create same part in wildfire2.0 but i cant. Any idea?
Thank you very much!
2006-02-28_014546_3dcurvepattern_2001.prt.zip
Im new in wilfire2.0 and need your expertise for my problem.
Attached is a part created on proe2001. A pattern following a 3d curve.After creating the curve, i created a pointon the curve with the length ratio option. i then created my revolve protrusion using a make datum sketching plane (through point, normal to curve) and make datum reference plane for sketching (normal to created sketching plane, through point). I patterned the createdrevolved protrusion and then, viola!, the part is created.
I tried to create same part in wildfire2.0 but i cant. Any idea?
Thank you very much!
2006-02-28_014546_3dcurvepattern_2001.prt.zip
