polysurface to continuous surface

[swf-1]

Hi All,


Working in WF3. Trying to determine the best way to make the surface continuous. This was extruded from a dxf that I imported into a part file.I can go into legacy mode and create a spline from thru points to make a single line however that takes a lot of time. Are there any surfacing tricks that I could use to achieve this? I have tried the advanced functions but with no luck. I don't have STYLE


Thanks Steve

 

[Zaki]

You dont need to create spline via lagacy. Just make sketch on any plane and use dxf lines as guide and make splines, arcs whatever you like and make approx 95% close sketch then extrude it.