PRO/E WILDFIRE CRASH PROBLEM !!!

[nawaz]

Hello friends,



I have an assembly file which i created in top-down design approach n every thing was fine till now. after my lunch break i tried to open the file, but pro/e crashing abruptly.



i could open all other sub-assly files n part files(most of them r sheet metal parts) but when trying to open main file n first sub-assembly file, pro/e crashing abruptly without giving information or any message.



i checked for all possible things like Network card, graphics option in config.pro.



i'm using wildfire datecode 2003490. here with i'm typing the contents od std.err and std.out......



std.out:



WARNING: PREPC1 (this is my system name) appears to have the loopback address 127.0.0.1 as IP address

This may imply that processes on PREPC1 may not be able to connect to non-local processes



Raisin signal: 11





std.err:



ERROR - D:\PTC\data\CONFIG\config.pro, linenum 7 : Keyword 'PURGE_LEVEL' is not valid.

ERROR - D:\PTC\data\CONFIG\config.pro, linenum 15: Keyword 'START_APPMGN' is not valid.

ERROR - D:\PTC\data\CONFIG\config.pro, linenum 25: Keyword 'USE_DIMENSIONED_EDGES' is not valid.

ERROR - D:\PTC\data\CONFIG\config.pro, linenum 49: Keyword 'MENU_HORIZONTAL_HINT' is not valid.

ERROR - D:\PTC\data\CONFIG\config.pro, linenum 51: Keyword 'MENUITEM_FONT' is not valid.

ERROR - D:\PTC\data\CONFIG\config.pro, linenum 65: Keyword 'CONTINUE_FROM_OSS' is not valid.

ERROR - D:\PTC\data\CONFIG\config.pro, linenum 76: Keyword 'SHADED_POSTSCRIPT_BACKROUND' is not valid.

ERROR - D:\PTC\data\CONFIG\config.pro, linenum 95: Keyword 'TREE_PLACEMENT' is not valid.

ERROR - D:\PTC\data\CONFIG\config.pro, linenum 104: No value for keyword 'SAVE_OBJECTS'.

ERROR - D:\PTC\data\CONFIG\config.pro, linenum 215: Keyword 'FAMILY_TABLE_EDITOR' is not valid.

ERROR - D:\PTC\data\CONFIG\config.pro, linenum 309: Keyword 'SKETCHER_OVERVIEW_ALERT' is not valid.

ERROR - D:\PTC\data\CONFIG\config.pro, linenum 310: Keyword 'SKETCHER_README_BUTTON' is not valid.



pls help needed from some one at the earliest....!!!



thanx in advance



-Nawaz

 

[Brian_Adkins]

What did PTC tech support say when you called them?



-Brian

 

[donha]

Try rebooting? If you still crash, your data may be corrupt. Brian is right, then time to ask PTC for help.

 

[nawaz]

Hi Brian & Donha,

Thanks for your reply. yes data is corrupt. i opened each file one by one n then found one part file was corrupt. when i try to open this part file pro/e was crashing. so i created the part again n deleted the corrupt part then its ok n as usual i have to redefine respective constraints.



i have not contacted ptc. but any way i sent this info to our reseller in Greece. i hope i'll get the reply after olympics are over...



but this is some thing peculiar. i found the version 20 and 2001 are robust...!!!



Any way thanks for ur replies.



-Nawaz