Pro-Engineer and Esprit

[JBeckley]

Is anyone using Esprit in conjunction with Pro-E?



We are a mid-sized manufacturing company, using an old 2-d mastercam version. Over the past two years we've transferred our engineering to Pro-E, but the Pro/NC cost and implementation is quite expensive.



We've been approached by dptechnologies. Any thoughts on Esprit and its interface with Pro-E?

 

[adicar01]

Hi I was using the Esprit and Pro/E few years ago.

The Esprit actually was used for Wire EDM.

In my oppinion is good software for machining. But I never try it on 3+ Milling. If you want to use this, first I will find the Esprit forums and find the bugs for programing. Is very dangerous to work on blind.



Adrian