G
Guest
Guest
Hey everyone!
I've been having issues with Pro/mechanica crashing right in the middle of an analysis. What happens is (even in quick check mode) during the time period that Pro/M is doing its AGEM stuff (creating elements), the screen will start to disappear from top to bottom, then the program will just, die! - As if it was never running.
This normally only happens during huge pressure vessel system analysis'.
The system I'm running on is a 3Ghz, with 1GB RAM - and about 14 GB of swap space on my harddrive...
Any ideas why this could be happening? I was wondering if there is a Config.pro setting that would change this phenomenon.
I've been having issues with Pro/mechanica crashing right in the middle of an analysis. What happens is (even in quick check mode) during the time period that Pro/M is doing its AGEM stuff (creating elements), the screen will start to disappear from top to bottom, then the program will just, die! - As if it was never running.
This normally only happens during huge pressure vessel system analysis'.
The system I'm running on is a 3Ghz, with 1GB RAM - and about 14 GB of swap space on my harddrive...
Any ideas why this could be happening? I was wondering if there is a Config.pro setting that would change this phenomenon.