Proe exits during part family table verif

[Lhann]

I am using WF3 M140. When performing a verify within a family table Proe unexpectedly exits. This a family table that define various text on the surface of a base plate partwith about 15 instances. When i modify the generic, open the family table and perform verify, Proe will exit. Any ideas on what is causing this?

 

[design-engine]

My guess is the script is failing your geometry.Guessing is the best way to start solving problems with anything even with car problems.Instead of using Verify try this. Close the Generic part.... open back the generic part and test the old way without using Verify. Open the instance you want. If the instance works and it probably will not... fix the failure then go back to the generic and verify again.Verify was added ... I don't remember when. WF2.0 probably.
Edited by: design-engine