put a draft on revolved part

[Peka]

Question :Why can't I put a draft on the outside face of a revolved part ?


See also attached part.





peka2006-03-28_064332_draftpart1.zip

 

[[-Skint-]]

There may be a correct way (or workaround )to achieve what you are looking for, but basically the draft (angle) is an angle which comes from a perpendicular plane or face,there is already a draft angle of sorts on the outside face which has been defined with the original revolve sketch.

 

[govindswaroopm]

If you really require draft to be given, it can be done on a perpendicular face only. As the draft is already given in revovle sketch, it wont accept another draft.


I am wondering why you require two drafts on the same surfaces )