Hi
I have Pro/NC and i'd like to be able to machine stuff for fun/small prototypes using a Roland MDX 20 Milling Machine
Has anyone set Pro/NC up to do this? and if so what's involved? and what's the best way of acheiving this?
Ideally i'd like to apply toolpaths to my Pro/E models within Pro/NC. Then PP output. Then import G Code? within Roland software/controller and then run!
Any help, advice, pointers would be greatly appreciated...so thanks in advance
Ben
I have Pro/NC and i'd like to be able to machine stuff for fun/small prototypes using a Roland MDX 20 Milling Machine
Has anyone set Pro/NC up to do this? and if so what's involved? and what's the best way of acheiving this?
Ideally i'd like to apply toolpaths to my Pro/E models within Pro/NC. Then PP output. Then import G Code? within Roland software/controller and then run!
Any help, advice, pointers would be greatly appreciated...so thanks in advance
Ben