I am trying to show a section on a drawing to shows dimensions. The part was created, and imported from the customers drawing program, not sure which, and is in surfaces and quilts. These show up as purple on the drawing. But I am unable to display the sections which were created in the part mode, or even any created in the drawing mode. The sections created in the part mode do not show up in the list of available sections to display. I tried to create a section in the drawing mode, which now shows up in the part file, but still will not display on the drawing.
Pulling my hair out. Not to mention, the file is 32MB and every change takes 5-20 minutes if a regen is needed.
Thanks in advance!!
Pulling my hair out. Not to mention, the file is 32MB and every change takes 5-20 minutes if a regen is needed.
Thanks in advance!!