Showing cosmetic sketch only in drawing

[mmadetzke]

In my drawing, I would like to have a view where ONLY the cosmetic sketch I have created in my model is visible.


A little background: I have created a cosmetic sketch that uses the model references. Now I would like to dimension this sketch in a drawing, but I cannot remove the model from the drawing. I have tried erasing all of the lines and different layer combinations, but no matter what I do, I cannot remove the outline of the original model.


Does anyone have any suggestions for viewing only a cosmetic sketch?

 

[megaladon]

you couldsavethe sketch while in sketcher and bring it as lines only in a drawing and group them


or start a new part using the same saved sketch and add it to your drawing

 

[mmadetzke]

Those suggestions would work, but I would lose my original references to the model. In the future, if changes are required to the model, the drawing would not get updated and I would have to do the process over again.

 

[jeff4136]

[url]http://www.mcadcentral.com/proe/forum/forum_posts.asp?TID=30 518[/url]help any?

 

[vesko]

you can make layer with solid geometry and blank it only in a drawing.

 

[mmadetzke]

Jeff,


That article is exactly what I was looking for. Thanks.