Sketch error

[Pliso]

Hi all, maybe stupid question but where can I make sketch analyses to see what is wrong where is section open?


Thanks

 

[[-Skint-]]

Are you using wildfire 4 ? There are new icons in the sketch dashboard which allow you to see the sketch as a coloured patch if it is closed, when it isnt closed you can highlight the gaps in larger red dots.


If using a lower release, try pulling parts of the sketch around ( then Undo ) until you find the area thats broken ?


This topic comes up quite often. Wildfire 4 has made it a little less painful.

 

[Pliso]

Unfortunately I'm using WF2. I had a lot of problems to find out where the sketch is open after modification.


but thanks anyway.

 

[csusie]

use your extend/trim trimming tool at every corner to seal the gap.

 

[sip]

Also, delete/undoall the entities in the sketch one by one to check for duplicate entities.


Sip
Edited by: sip

 

[Pliso]

Thanks for advises. Finally there is non analyses in sketcher to find out where gaps or double curves are?


Pliso

 

[[-Skint-]]

Thanks for advises. Finally there is non analyses in sketcher to find out where gaps or double curves are?


Pliso

Unfortunatly Not

. Like I say above though, WF4 has made things a little easier.


If your bringing in from Autocad, I find its much easier to spot the double entity`s in CAD, the line thickness shows up a little differently.