Surface creation

[users4]

Hi all,


I have a model that is to be completed. When i tried to create the surface, I got void spaces at the two sides. Whatever I tried, those voids are not being filled up.


I have attached the .prt file. What I tried to do is this- created an arc with a center and end points that are the two points on the edges of the outer ellipse on each side. Then tried to join all those edges to form a surface.......... this technique didn't work either. I somehow need to close up those voids.


Any suggestions??


Thanks and best regards,


VR.

 

[users4]

Hi,


here is my .prt file.


2006-05-11_153623_leaflet.prt.zip

 

[vnavi]

oops, it is an education version file.... I don't know what model you want to be completed! Please post at least an image of it.


Cheers

 

[users4]

Hi,


My ultimate goal is to make an assembly with two separate models that I have. I'm attaching the two files here and also a picture (in MS Word) of the final model. I have to do the assembly in such a way that the model in the file called leaflet.prt has to be wrapped around the framein the model.prt file. For this I have to somehow close the leaflet completely (it perhaps might look as a cylinder). But whatever I did, the void spaces at the sides could not be closed.


Also the leaflet should have a uniform thickness of 0.1mm.


Here are the files.....


leaflet.prt--------- This contains the leaflet model


model.prt---------This contains the frame model


The other picture isthat of the complete unit.2006-05-12_092704_Model.zip


Thnaks,


VR