Sweep Issue

[Prim3]

Hi, I'm doing a project and for that, my part (Crank Shaft) needs to be a length of 270mm.

Now the problem I'm having is I used the filet feature to make it curvy but then I need to use the Sweep method so I can make a cylindrical shape out of the crank shaft.

I got a bit of it. Can't seem to get it again. I just need to make it longer. I'm attaching a picture. Thanks!



Now as you can see, if I could make the bar a little longer (where the point is), then that'd be great. Thanks again!

PS: I'm sorry if I was not allowed to use the image tags (as it stretches the board), but I couldn't get it to work with the URL tag. Sorry!


Edited by: Prim3

 

[Guru.hm]

i think u have not constrained ur line sketch completely..i.e., u should end ur line at origin. at that point the other plane will be perpendicular to it. now u have to start the next drawing on tht plane i.e., circle....


try it, if u didnt get it i'll post some images next time...