Threaded Holes on a family Table

[jraquet]

Is it possible to have threaded holes on a family Table?


If I try the system tells me that the dimensions (diameters) cannot be included on the table. I wanted to make a threaded hardware set using family tables but have not had any luck...


Let me know if there is some secret method...

 

[ReinhardN]

diameters in hole tool are write protected. This makes sense, because you may get corrrect geometry but will get incorrect hole notes.
There is a config.pro option to override that.
You should model a hole and insert a cosmetic thread as in 2001. Then you have no limitations.
I avoid this tool.

http://www.ptc.com/forums/viewtopic.php?t=1095&highlight =hole+tool

 

[jraquet]

Thanks Reinhard, that is what appeared to be happening.


Great analysis on the PTC.com forum. Keep up the good work.