Values in Pattern Table rounded to 0.01"

[Peter1234]

I have a pattern table. When I save the table, close it an open it again all dimensions have been rounded to the nearest 0.01 inch.

For my application, I need thousandths of an inch in the table. Is there a setting somewhere that will allow me to do this?

Thanks!

 

[DonChunior]

I assume, the accuracy in the model is set to a absolute value of 0.01. This setting comes with the start model. If you need 0.001, you need to change it in the newly created model.


Regards, DonChunior