Join our MCAD Central community forums, the largest resource for MCAD (Mechanical Computer-Aided Design) professionals, including files, forums, jobs, articles, calendar, and more.
The procedure works for a single direction path, but does not seem to work for 2 direction (leading edge - trailing edge).
In the case of the vertical stabilizer, I have the following:
2 problems:
- I have two different directions (front and rear)
- I need to project the var sweep on the aircraft body.
Would you have some recommendations on how to do so?
I could probably go for the "boundary blend tool" instead but for this I thinck I would need to project the wingprofile (sketch 4) on my fuselage. Problem is... I have no clue how to do it!
You are missing a fundamental of the VSS.
In order for the section to vary it must be
dependant on the trajectories. That means
the section must be internal and constrained
(by dimensions or sketcher constraints) to
the trajectory reference points.
Note that when the section is not dependant
on the trajectories (as with the Use Edge
projections) use the Constant Section option.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
