Weld display

[jfixsen]

I've got a weld in my assembly and it's showing up in the model tree, but in the model, it isn't visible. If I run my cursor over that are, it highlights though. I can't seem to find anything to make it show up as a surface though and I know that at my last job they did. The only thing that I can find in the config.pro is "weld_color" and if i set that to (0 0 49) like they suggest, it still doesn't do anything. In "View", "Display Settiings", "Model Display", the weld box is checked for Welds. Does anyone have the answer?

 

[mechanical01]

Ithink this is hardware problem. You should check your graphics card. I HAVE gone through with the same problem where sketch were present in the model tree(unhide) but they didn't appear in the model.

 

[davisdony]

in view- display setting- model display- shade -small surfaces

try checking that