XHATCH

[athiesen]

Is there a way to hide xhatch on 2D cross-section with model edge visibility area? The solution that I found is increase the lines spacing, but if I change the model dimensions, sometimes, one line appear. (Pro-E Wildfire 3.0)

 

[vlad1979]

Don't think there's a way to hide xhatch on 2D-sections.


But there is a way around, make a cut where the section is, make an instance to show the cut only in the instance, and put a view of the instance in the drawing.


Like this:


View attachment 2919

 

[SRINIVASANIYER1]

The solution that I found is increase the lines spacing, but if I change the model dimensions, sometimes, one line appear. (Pro-E Wildfire 3.0)

increase the line spacing to a value your model dimensions will never be. e.g. if your model overall dimentions are say 200 X 200, you may set the line spacing to a value = 5000.