3D projection etc

[zargon12]

Hi
I have my model all ready i need to do Orthographic projections of my model, with all the dimensions shown and for circles have to show the center lines and hidden lines. I haven't used the drawing feature at all. When i first had a there were two dimension on each view which were not orthographic (how do i do that) and when i try switching to the wireframe/hidden view 2 of the views change other one doesnt! How do i add dimensions and show those centerlines and the dimensions i have were in inches but in my model i set all of it up as mm so how do i convert that for drawing mode? Please help

 

[anand_m_s]

Please go through this tutorial [url]http://www.me.cmu.edu/academics/courses/NSF_Edu_Proj/Wildfir e_short_course/tutorial7.htm[/url]

 

[zargon12]

Hi thanks for the tutorial. I have a problem. My datum planes aren't exactly front = front. When i started i had my front as right so i renamed it so it will make it easier. In the assembly i have all the new datum planes as well. In Pro E 4 when i do the general drawing according to the tut and select views none of them are actually front or right i can do the top then i tried projecting that and i got a left view. So how do i get around this problem? I tried rotated view but i dunno how to use that.

 

[anand_m_s]

I have prepared a small tutorial for you. I have used WF 2.0 to make this tutorial. I hope the things are not very different in WF 4.0


2009-04-15_050822_InsertView.rar


Regards,


Anand

 

[zargon12]

Thanks i got it.