Can’t see holes in my drawing

[iquack]

When I am dimensioning a part in drawing (WF 3) ,the holes don't displayunless I zoom in close. If I set the view to show theentire sheet, I can't see any of the holes on the part unless they are fairly large. I have looked through all of the config options and can't find anything. It is driving me nuts, can anyone help?





Thanks

 

[appinmi]

I don't know if it will help in drawing mode, but you might try setting edge_display_quality to VERY_HIGH.

 

[iquack]

Thanks for the response, but I already have my edge display set to very high. I did notice this morning that any sketched circles that you draw in drawing mode also show the same behavior. If you draw a 0.05 inch diameter circle on a blank 8 1/2" x 11" sheet, it is not visible when the entire page is displayed. It only shows up as you zoom in. Small sketchedrectangles or other shapes do not seem to be a problem.

 

[sumeet_k29]

I think that this is a display problem. .05" ~ 1.27mm which is very small hole as compared to the sheet size that you have.Just take a print of that drawing and you will see that the holes are clearly visible.

 

[Dell_Boy]

Possible workaround,

try making the holes in the part larger while you do the dimensioning and set them to the correct size when you have finished.

 

[iquack]

I had an early build date on my software. I installed the latest build (Date Code M010) and everything seems to work great.


Thanks for the input.