Creating GD&T Datums

[ejd1984]

I've just started using WF5 (07/18/2011), and can't find the function to create datums while in the drawing (i.e. Datum A on a specific surface). I've been doing that in past releases of Wildfire.

Is there something I'm missing?

 

[garymig]

did you try under annotate then that little tab icon to the right of insert on the lower part of the rib, that opens up to model datum plane.


Gary

 

[ejd1984]

That was it! Thank you so much!!!

*We've been forced to this upgrade form WF3 to WF5 - with no traiing at all, just right into the deep end.