first... when i create hole in drawing it's diameter dimension witness line starts right in center point but i wanna to start it from end of center axis...is it posible? i mean not by draging it's handle (cause this way it stay at droped place and when i change diameter of hole its not starting at axis end)
second... same problem with linear dimensions...if i create dim in sketch for example above extruded rectangle but i wanna have it below in drawingi have to drag it - its OK but witness lines stay atached to edge ... by draging them down i haveto place them only "by the eye" ...
...but will be nice to atach it's handles to low edge and let's proe make gap between edge and witness line...
second... same problem with linear dimensions...if i create dim in sketch for example above extruded rectangle but i wanna have it below in drawingi have to drag it - its OK but witness lines stay atached to edge ... by draging them down i haveto place them only "by the eye" ...