Failure of curve intersect

[Robin_lee]

I just met one strange issue, i creat a skleton file, but the intersect command does not work. ps. i've selected the two surs or two sketch lines, and i am pretty sure they canintersect, the intersect commandlightlight. Press the command and nothing happen....

Bother me a lot. Thanks in advance!

 

[krow72]

post some pics or a file for us to examine please.

 

[Robin_lee]

Thanks, krow72


Attached a picture. you can see the intersect command be ready, but it just does not suceed. ps. proe does not give any failure report.


I also attached a file,however it is a wf5 verison.


2011-08-02_210809_1234.zip


View attachment 5318

 

[krow72]

I do not have WF5 so I can not open the file. Try to pick one surface (say the red one) then hit the intersect command then pick a plane (plane that the yellow surface is on).

 

[kdem]

The problem is caused by your Reference Control settings. The settings you have only allow you to pick publish geometry as references. If you change the setting to all you will be able to intersect the geometry.

 

[Robin_lee]

Hi,kdem, i checked the reference control, it is already selected "all"


any other solution?


View attachment 5319

 

[Robin_lee]

Hi, Krown72, I tried, it does not work either

 

[solidworm]

Right click on 123.prt in model tree>reference control, then in "shared" tab,select "All" for "geometry Allowed for referencing". then you can invoke the intersect command.

 

[bramwensink]

Make 1 surface langer than the other one. maybe that helps

 

[Robin_lee]

Yes ,I got it!!!!


kdem and Solideworm, thanks very much, you give a MVP answer.


I used to using the default settings too much.


What is the situation for this selection of "pubulish geometyr only"?


and is there any other command be controlled by this selection?